What tools do I need for a DIY Exhaust Manifold porting?

[apgarabu]

I am bound and determined to do the DIY exhaust porting (port match) on my wrx.  Within the next few weeks i will be pulling the OEM manifold off to check for exhaust leaks (slow spool) and replace gaskets, etc.  While they are off i will be porting the openings on the manifold to match the heads/crosspipe/uppipe etc.  

What tools do you recommend?  I've heard a dremmel and a Carbide burr work good, but others say this will take forever.  Is this correct?  What is another cheap / time efficient method?  

[JBamin]

air compressor and a die grinder... safety gogs

[STi 5]

If you are thinking about buying an STi, why take the time to do this, wait till you get the new ride then do it.  Unless you want to practice before getting the STi that is.

[apgarabu]

If you are thinking about buying an STi, why take the time to do this, wait till you get the new ride then do it.  Unless you want to practice before getting the STi that is.

because the wifey told me i cant.

[JBamin]

If you are thinking about buying an STi, why take the time to do this, wait till you get the new ride then do it.  Unless you want to practice before getting the STi that is.

because the wifey told me i cant.

none the less a dremmel wont have enough ass to get u even started..

[RossLH]

because the wifey told me i cant.

Tell her I said dont make me come down there.

[apgarabu]

because the wifey told me i cant.

Tell her I said dont make me come down there.

dude, i wouldn't mess with her.  she's pregnant.  even im scared of her.  she would snap you in half.